使用Bresle方法按照ISO 8502-6/ISO 8502-9來測量鹽污染

	測試步驟： 從鹽分貼片中心，取出保護包裝和泡沫。  Remove protective backing and foam centre from the patch. 在表面貼上鹽分貼片，緊壓邊緣，實現完全密封—確保測試艙中有最少的空氣 Apply the patch to surface and press firmly around perimeter to achieve a complete seal - ensuring that a minimum amount of air is trapped within the test compartment.
	用3ml 純水填入注射器。 通過海綿泡棉周長以大約30°到測試面的角度，將注射器插入貼片 , 使其穿過泡棉到測試的貼片。  Fill the syringe with 3.0ml of pure water. Insert the syringe into the patch through its foam perimeter, at a 30° angle, so that it passes through the foam into the test compartment. 注入水到測試的貼片。 如果有必要, 去除貼片內剩余空氣 。 Inject the water into the test compartment. If necessary remove the remaining air within the compartment.
	期間商定的時期內 , 無需取出針 , 吸和重新注入該溶液到貼片至少四次 。 During an agreed period of time, without removing the needle - withdraw and re-inject the solution back into the patch, at least four times.
	在該期間結束時 , 盡可能多提取溶液 。 At the end of the period extract as much solution as possible. 從貼片拔掉注射器，使用合適的電導率儀例如Elcometer138來測量溶液中的電導率。 Remove the syringe from the patch and measure the conductivity of the solution using a suitable Conductivity Meter such as the Elcometer138. 計算鹽分含量： 如果測試讀數的單位是uS/cm,那么用讀數乘以1.2,可得到鹽分含量的單位mg/㎡。